I had to replace the headlight/turn signal switch (called combination switch in Hyundai parts list) on my wife's 2007 Accent.
Tools:#2 Philips, 1/8" and 3/16 straight screwdrivers and key
Removed 3 screws, 1 underneath, 2 hidden by steering wheel. Turn the key so you can turn the steering wheel.
Use the slotted screwdrivers to pry the plastic apart
This one has tilt steering so I pulled it down to help get the two pieces apart.
The bottom plastic piece has small plastic pins ( 1 on left, 3 on right). Be careful when reinstalling.
Remove plug by pushing in lever. I also needed a straight blade to help get it out.
Use straight blade screwdriver to press in tab and slide out.
The switch has a white tip that goes into a slot in the column.
This is the upper plastic piece, the clip slides into a slot on top of the column.
Push the new switch into place, make sure it is seated.
Push the blue plug into place, make sure it is seated.
Take you time when putting the plastic together. Took a couple minutes to get the four plastic pins and clips lined up before I could snap them together. Use the tilt steering if you have it to wiggle the pieces into place.
Total time was about 20 minutes. That included taking the pictures.